Product features

Gloss Level

Flat

Available in

4L

10L

How to apply

Surface Preparation

Ensure surfaces to be painted are clean, dry and free of contamination. Walls should be wiped down with a mild detergent and rinsed clean with fresh water, even if they don't appear to be dirty, to ensure removal of any surface contamination and ensure the paint has a clean surface to adhere to

New Work

Surface must be clean, dry and free from all surface contamination. Where applicable, fill cracks with a suitable filler then sand and dust surface down. Prime and or undercoat surfaces with appropriate products as required.

Repaint

Remove all loose and flaking paint by scraping or sanding previously painted areas and sand smooth. Surfaces must be clean, dry and free from all surface contamination. If mould is present, treat with bleach then rinse clean with fresh water. Spot prime bare areas with a suitable primer or undercoat. If painting over enamel surfaces, sand thoroughly and apply one coat of oil based undercoat or other suitable product to promote inter-coat adhesion.

Coats

Apply two liberal coats by brush, roller or spray. Do not overspread. Keep brushes and rollers working freely by rinsing occasionally in clean water.

Clean Up

Scrape excess paint from equipment into a separate container. Wash up with water. Do not dispose of paint or wash water in drains or sewers. Avoid exposure to steam for 48 hours.

Coverage

Up to 16m²/litre, depending on nature of surface. Coverage will be lower on rough or absorbent surfaces

Recoat

Recoat after 2 hours at 25°C and 50% relative humidity.

Stirring

Stir paint with a 25mm wide flat stirrer in a circular lifting motion for at least 5 minutes before use. It is always recommended to stir paint before use to ensure that the colour tints are dispersed evenly throughout the paint.

Temperature

Do not use at temperatures below 10°C, above 35°C or when humidity is excessive.